For A Limited Time Only!
These beautiful handmade incense burners are available in 4 colours.
When using these backflow burners it is important to have Incense cones with a hole in the bottom. This hole needs to be matched up with the hole on the burner. Once burning the smoke density is greater than the density of the air and this causes smoke like water to flow from the higher positions to the bottom. Some residual may be left over but this can easily be washed off all products. Please burn all incense carefully and safely.
Incense Type: Cones (with holes), and Sticks
- Take one of our special Zen Incense Cones (included for FREE for a limited time only) and light the top of it with a lighter for about 15 seconds. (It’s easier if you tilt the cone sideways while you do this, so that you just get the very tip of it).
- On your incense burner, somewhere on the top of the mountain next to the monk, there is a little hole. Take the incense cone that you just lit, and place it on that mountain so that the hole at the bottom of the incense cone aligns with the hole on the top of the incense burner. The tip of the incense cone that you lit should be facing up.
- Wait about 10-20 seconds, and make sure that you are not in a windy area.
- Voila! The waterfall effect begins.